members module show big pictures (height) wrong

GK User
Fri Jan 06, 2012 1:38 am
I hope I can explane what I mean, my english isn't very good... :blush:

I use jomsocial and the members module from gk. If a user have a userpic with a high Y size (as example 400x50px), the module looks a littele bit wrong. The picture is shown full, but small.
I think to take little quadrat of the picture is a better way.

I have made a picture of it. Red is the wrong sized picture. Green shows a area, what insted of the full picture is used. Normaly the middle of a picture. Other sides as facebook do the same.

thx
User avatar
Senior Boarder

GK User
Fri Jan 06, 2012 10:56 am
Hi,

Can you give me your site URL?
User avatar
Platinum Boarder

GK User
Sat Jan 07, 2012 4:11 pm
Hello,
yes, but I have a password on it. So pls contact me on my mail for the password.
[email protected]

Page http://www.metalszene.de

Thank you


Don Lee wrote:Hi,

Can you give me your site URL?
User avatar
Senior Boarder

GK User
Sun Jan 08, 2012 12:14 pm
Hi,

Thank you, please send the access info to me via a PM!
User avatar
Platinum Boarder

GK User
Mon Jan 09, 2012 5:45 am
How can I send a PM? Doesnt see any link...
User avatar
Senior Boarder

GK User
Mon Jan 09, 2012 6:01 am
Please go to User Control Panel > Private messages
User avatar
Fresh Boarder

GK User
Sun Jan 22, 2012 7:05 am
Hello, I'm assuming this problem was solved via private messaging but I am encountering the same, if not a very similar, problem with the members module. If you could post the solution here in the forum it would be GREATLY appreciated.

Looking forward to your response,

Thanks!
User avatar
Fresh Boarder

GK User
Sun Jan 22, 2012 5:02 pm
blackcrowne wrote:Hello, I'm assuming this problem was solved via private messaging but I am encountering the same, if not a very similar, problem with the members module. If you could post the solution here in the forum it would be GREATLY appreciated.

Looking forward to your response,

Thanks!

I did not get the PM to fix so please just PM me then I will know how to fix it.
User avatar
Platinum Boarder


cron